Rastergraf Eclipse3 Series Manuel d'utilisateur Page 31

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 85
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 30
Rastergraf
General Information 1-23
1.6 Monitor Requirements
Rastergraf graphics boards can be used with a variety of monitors. For
best performance a monitor should have the following features:
VGA compatible 5 Wire RGB with separate TTL horizontal and
vertical sync or 3 Wire RGB with sync on green (see note below)
Switchable Termination (for monitor loopthrough)
Height, pincushion, width, phase, and position controls
Autotracking horizontal and vertical synchronization
See tables in Section 1.4 (above) for basic timing requirements
Notes
The Eclipse3 software defaults to standard Multiscan 5-wire RGBHV
(VGA compatible) settings. If you require Sync On Green, be sure to
install SYNC ON GREEN jumper.
Eclipse3 graphics boards DO NOT support interlaced operation.
Vue de la page 30
1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 84 85

Commentaires sur ces manuels

Pas de commentaire